5 points for filling and charging the dry battery of scissor lift
1 Remove the battery vent cap from the battery vent of the scissor lift and remove the plastic seal.
2 Fill the battery electrolyte (electrolyte) into each battery until the liquid level can pass the electrode plate. Do not fill up to the highest level before the battery charging process is over. Excessive addition of liquid can cause the battery electrolyte to overflow during charging. Use soda and water to neutralize spilled battery acid.
3 Install the scissor lift battery vent cover.
4 Charge the scissor lift battery.
5 Check the battery electrolyte level at the end of the scissor charging cycle. Fill the bottom of the filling pipe with distilled water. Do not add too much.
