Solutions to Noise and Leakage of Lifting Platforms
As a commonly used equipment in industrial production and transportation, lifting platforms may encounter various problems in actual use. Among them, leakage and noise are relatively common faults. When facing these faults, we must promptly Find the cause, reduce noise pollution and reduce the occurrence of accidents, and let you know about the solutions to the noise and loopholes of the lifting platform.
Noise solution, check the connection between the components before using the lifting platform, the amount of lubricating oil in the box should meet the standard to ensure good lubrication. Lubrication between components has a direct solution to problems such as wear and noise reduction. Therefore, in the drive control device of the lifting platform, attention should be paid to maintaining a good lubrication effect between the bearings. Check whether the air cylinder, oil pipe, motor and other components are well sealed and there is no air leakage.
Vulnerability solution, the safe working voltage of the lifting platform is normally below 36 volts, and the leakage phenomenon will bring a series of safety risks, so if leakage occurs during operation, you must stop working immediately, cut off the power immediately, and transfer the lifting platform. Go to a safe place and measure with an electricity meter when you use it again. In addition, the lifting platform may also leak electricity due to the burning of the transformer, and it cannot be converted into a safe voltage. At this time, the power supply needs to be turned off, and the power distribution board is turned on to determine whether the power distribution board is burnt.
