Mobile scissor lift parts is a kind of aerial work machinery equipment. With the increase of market demand, mobile scissor lift parts are more and more widely used in people's life and work. So, how to operate mobile scissor lift parts safely?
1. Before work, carefully check the scissor lift parts, focusing on checking whether the screw connection is reliable, whether the hydraulic pipeline components are leaking, and whether the wire contacts are loose or damaged.
2. Before lifting the scissor lift parts, place the four-corner legs. The four legs should be firmly supported on the solid ground, and the worktable should be adjusted to a horizontal state. Turn on the power, the indicator light should be on. Then start the motor, the oil pump works, lift up and down once or twice under no load, and check that all parts are operating normally before starting work. When the temperature is lower than 10 ℃, the oil pump should be operated for 3-5 minutes, and the oil pump can be operated normally only after it is confirmed that it is working properly.
3. After entering the platform, the operator should close the guardrail door, insert the latch, and fasten the safety rope. The center of the load should be located at the center of the work surface.
4. Lifting and lowering: press the "lifting" button to start the motor, the motor rotates, the hydraulic system works, the oil cylinder extends, and the platform lifts; when the lifting is required to work, press the motor "stop" button, the platform stops lifting , You can work, if you do not press the "stop" button, the travel switch works when the platform rises to the calibrated height, the platform stops at the calibrated height. After the work is completed, press the "Descent" button, the solenoid valve is activated, and the oil return of the cylinder is connected, and the platform is lowered by its own weight.
5. Overloading is strictly prohibited during the use of Scissor Lift Parts. Operators on the platform must not move during the lifting and lowering process.
6. When moving or pulling the hydraulic platform, the supporting legs should be retracted and the platform should be lowered to the lowest position. It is strictly forbidden for the operator to move the platform when it is in a high position.
